Low RF Tappers allow a portion of the signal to tap off to a branch or an antenna while allowing the rest of the signal to pass through with a minimum of loss.

For low SWR on the main line input and on output ports all tapper ports must be terminated in 50Ω terminator device or a further 50Ω cable system or an antenna.

Tappers operate similarly to directional couplers but with no directivity over a broad bandwidth spectrum. All PIM values are measured against IM3 (dBc@2*43dBm) and are lower than ≤-150dBc. Permissible power is 200W, Impedance 50Ω, all tappers are rated IP66.